Pro AV Catalog
Manufacturers
PRODUCT CATEGORIES
Matching Keywords
Model Numbers
Request Quote
All Products
Dual HD/SD-SDI Digital Auto Signal (2x1) Changeover
Model: 500ACO2-HD/SD
- Auto detection of six signal types
- Five modes of operation (including VistaLINK®)
- Auto changeover - two standalone auto changeovers or two link changeovers
- Manual DIP switch control - two independently controlled 2x1 switchers
- GPI Control - two independently GPI controlled 2x1 switchers
Compare
Project List
Product Info
Tech Specs
Documents
The 500ACO2-HD/SD dual HD/SD Autochangeover is designed to provide extension to the 5600ACO for HD or SD SDI, DVB-ASI, AES audio, bi-level/tri-level syncs and NTSC/PAL video.The unit can also be operated as a standalone changeover unit with two independent 2X1 switchers.The 500ACO uses latching relays to ensure maximum reliability and minimal disruption in the event of any failure.
- Auto detection of six signal types
- Five modes of operation (including VistaLINK®)
- Auto changeover - two standalone auto changeovers or two link changeovers
- Manual DIP switch control - two independently controlled 2x1 switchers
- GPI Control - two independently GPI controlled 2x1 switchers
- ACO Extension - slave unit of the 5600ACO (requires 5600ACO firmware version 1.2 or higher)
- Support for VistaLINK® monitoring and control
- Fully hot-swappable from front of frame with no BNC disconnect required
- Tally output on Frame Status bus upon loss of input signal for quality monitoring
- Latching relays maintain the current path on loss of power
- VistaLINK® capable for remote monitoring via SNMP (using VistaLINK® PRO) when installed in 500FR frame with 500FC VistaLINK® Frame Controller
- Switcher Audio Input Signal Type - AES/EBU
- Switcher Connector Type - BNC
- Switcher Type - Video
- Spec Sheet available - Yes
- Active Power: 6 Watt
- DC Voltage: 12 Volts
- Input Signal Types: Digital
- Number of Inputs: 4
- Number of Outputs: 2
- Number of Ports: 1
- Number of Video Inputs (Digital): 4
- Number of Video Outputs (Digital): 2
- Output Impedance: 10000 ohm
- Standards: SMPTE ST 292-1, SMPTE ST 259-A, B, C, D (143 to 540Mb/s), DVB-ASI, bi-level/tri-level syncs or NTSC/PAL video
- Number of Inputs: 4
- Connector: BNC per IEC 61169-8 Annex A
- Maximum Cable Length: 100m of Belden 1694A or equivalent cable combined input and output
- Return Loss: 10dB up to 1.5Gb/s
- Number of Outputs: 2 passive relay outputs
- DC Offset: 0V ±0.5V
- Inputs: Opto-isolated input with internal pull-up to +5V.
- Outputs: Normally 10k internal pull-up to +5V. Ground to rear panel when relay is in active position.
- Signal Level: +5V nominal
Dual HD/SD-SDI Digital Auto Signal (2x1) Changeover
69 kb
- Data Sheet
Project List
Request Quote
Thank you!
Someone will be in touch with you shortly.
Contact McCann Systems
close
McCann Systems
290 Fernwood Avenue
Edison, NJ 08837
USA
1-888-414-3806
www.mccannsystems.com
Contact in regards to this product:
Evertz
Model: 500ACO2-HD/SD
Request more information from a dealer near you
close
Request more information from a dealer near you