Pro AV Catalog
Manufacturers
PRODUCT CATEGORIES
Matching Keywords
Model Numbers
Request Quote
All Products
120V Phase-adaptive Power Module
Model: PHPM-PA-120-WH
- Provides capability for zone on GRAFIK Eye control unit to dim fully loaded circuit of lighting
- May be used to control incandescent, electronic low-voltage, magnetic low-voltage, and neon/cold cathode lighting sources, as well as Lutron Tu-Wire fluorescent dimming ballasts
- Automatically selects leading-edge or trailing-edge dimming for low-voltage transformers
- Provides power and dimming for one zone
- Up to 3 power modules may be wired on a single GRAFIK Eye zone
Compare
Project List
Product Info
Tech Specs
Related Products
Documents
The PHPM-PA-120-WH is a phase-adaptive power module, provides capability for zone on a GRAFIK Eye control unit to dim fully loaded circuit of lighting. May be used to control incandescent, electronic low-voltage, magnetic low-voltage, and neon/cold cathode lighting sources, as well as Lutron Tu-WireR fluorescent dimming ballasts. Automatically selects leading-edge or trailing-edge dimming for low-voltage transformers. Provides power and dimming for one zone. Up to 3 power modules may be wired on a single GRAFIK Eye zone. 120V control voltage, 120V load voltage and 16A/1920W capacity. Not for use with non-dim loads. 50/60Hz frequency, phase-to-neutral. Phase independent of control device/control voltage. Indoor use only. 135BTU/hour maximum heat output of module. Surface or recess mounting. UL tested.
Automatically selects between forward phase/leading edge (e.g., magnetic low-voltage) and reverse phase/trailing edge (e.g., electronic low voltage) dimming/output based on connected load. Patented RTISST circuitry compensates in real time for incoming line voltage variations, compensates for +/-2% change in RMS voltage/cycle and +/-2%Hz change in frequency/second. Provides air-gap off. Module protects itself during most temporary over-current and over-voltage conditions. Two LEDs on front of unit provide diagnostic information (visible when faceplate is removed). Each terminal accepts up to two 12AWG wires.
- Provides capability for zone on GRAFIK Eye control unit to dim fully loaded circuit of lighting
- May be used to control incandescent, electronic low-voltage, magnetic low-voltage, and neon/cold cathode lighting sources, as well as Lutron Tu-Wire fluorescent dimming ballasts
- Automatically selects leading-edge or trailing-edge dimming for low-voltage transformers
- Provides power and dimming for one zone
- Up to 3 power modules may be wired on a single GRAFIK Eye zone
- 120V control voltage
- 120V load voltage
- 16A/1920W capacity
- Not for use with non-dim loads
- 50/60Hz frequency, phase-to-neutral
- Phase independent of control device/control voltage
- Indoor use only
- 135 BTU/hour maximum heat output of module
- Surface or recess mounting
- UL listed
- Warranty - Yes
- Spec Sheet available - Yes
- Operating Temperature (Maximum): 104 F
- Operating Temperature (Minimum): 32 F
- UL Rated: Yes
- AC Voltage: 120 Volts
- Active Power: 1920 Watt
- Current Draw: 16 Amps
- Warranty (Length/Type): 2 Years Limited
PHPM-PA-DV-WH
- 120 to 277V Phase-adaptive Power Module
Power Module
1032 kb
- Data Sheet
Project List
Request Quote
Suggested Products
Thank you!
Someone will be in touch with you shortly.
Contact McCann Systems
close
McCann Systems
290 Fernwood Avenue
Edison, NJ 08837
USA
1-888-414-3806
www.mccannsystems.com
Contact in regards to this product:
Lutron Electronics Company, Inc.
Model: PHPM-PA-120-WH
Request more information from a dealer near you
close
Request more information from a dealer near you