Pro AV Catalog
Manufacturers
PRODUCT CATEGORIES
Matching Keywords
Model Numbers
Request Quote
All Products
120 to 277V Phase-adaptive Power Module with 3-wire Fluorescent Input
Model: PHPM-WBX-DV-WH
- When connected to 20A circuit breaker, provides capacity on 3-wire fluorescent dimmer for a full 16A load of lighting
- Used to dim incandescent, halogen, electronic low-voltage, magnetic low-voltage, neon/cold cathode, or Lutron Tu-wire lighting sources
- Phase-adaptive technology automatically selects leading-edge or trailing-edge dimming for low-voltage transformers
- Up to 3 power modules may be controlled by a single dimmer
- 120V control voltage
Compare
Project List
Product Info
Tech Specs
Related Products
Documents
The PHPM-WBX-DV-WH is a phase-adaptive power module with 3-wire fluorescent input. When connected to 20A circuit breaker, provides capacity on 3-wire fluorescent dimmer for a full 16A load of lighting. Used to dim incandescent, halogen, electronic low-voltage, magnetic low-voltage, neon/cold cathode, or Lutron Tu-wire lighting sources. Phase-adaptive technology automatically selects leading-edge or trailing-edge dimming for lowvoltage transformers. Up to 3 power modules may be controlled by a single dimmer. 120V control voltage, 120 to 277V load voltage and 50/60Hz frequency, phase-to-neutral. Not for use with non-dim loads. Phase independent of control device/control voltage. Automatically selects between forward phase/leading edge and reverse phase/trailing edge dimming/output based on connected load. Provides air-gap off. Module protects itself during most temporary over-current and over-voltage conditions. Two LEDs on front of unit provide diagnostic information (visible when faceplate is removed). Each terminal accepts up to two 12AWG wires. Indoor use only. 135BTU/hour maximum heat output of module. Surface or recess mounting. UL listed.
- When connected to 20A circuit breaker, provides capacity on 3-wire fluorescent dimmer for a full 16A load of lighting
- Used to dim incandescent, halogen, electronic low-voltage, magnetic low-voltage, neon/cold cathode, or Lutron Tu-wire lighting sources
- Phase-adaptive technology automatically selects leading-edge or trailing-edge dimming for low-voltage transformers
- Up to 3 power modules may be controlled by a single dimmer
- 120V control voltage
- 120 to 277V load voltage
- Not for use with non-dim loads
- 50/60Hz frequency, phase-to-neutral
- 1920 to 4432W capacity
- Phase independent of control device/control voltage
- Automatically selects between forward phase/leading edge and reverse phase/trailing edge dimming/output based on connected load
- Provides air-gap off
- Module protects itself during most temporary over-current and over-voltage conditions
- Two LEDs on front of unit provide diagnostic information (visible when faceplate is removed)
- Each terminal accepts up to two 12AWG wires
- Indoor use only
- 135BTU/hour maximum heat output of module
- Surface or recess mounting
- UL listed
- Warranty - Yes
- Spec Sheet available - Yes
- Operating Temperature (Maximum): 104 F
- Operating Temperature (Minimum): 32 F
- UL Rated: Yes
- AC Voltage (Maximum): 277 Volts
- AC Voltage (Minimum): 120 Volts
- Active Power: 4432 Watt
- Current Draw: 16 Amps
- Warranty (Length/Type): 2 Years Limited
- Frequency: 50/60 Hz
- Control Voltage: 120 V
PHPM-WBX-120-WH
- 120V Phase-adaptive Power Module with 3-wire Fluorescent Input
Power Module
1805 kb
- Data Sheet
Project List
Request Quote
Suggested Products
Thank you!
Someone will be in touch with you shortly.
Contact McCann Systems
close
McCann Systems
290 Fernwood Avenue
Edison, NJ 08837
USA
1-888-414-3806
www.mccannsystems.com
Contact in regards to this product:
Lutron Electronics Company, Inc.
Model: PHPM-WBX-DV-WH
Request more information from a dealer near you
close
Request more information from a dealer near you